Illuminated reticle

VIDEO

Reticle illumination is getting more common in modern rifle scopes. There are, however, two groups of illuminated reticles, meant for two different uses. In both cases, illumination of the reticle substantially increases effectiveness of such rifle scopes. Reticle illumination systems are divided to:

Twilight illuminated reticles
Daytime illuminated reticles

Twilight illumination is used for better reticle recognition in low light situations, when non-illuminated reticle would be hard to see. Such illumination systems must offer fine adjustable intensity, since over illumination of the reticle will cause problems seeing the target behind it. This is especially important when hunting in low light, where fine-tuning of illumination intensity level is one of the main parameters on which rifle scopes are judged. Preferably, such rifle scopes have only the central dot in the reticle illuminated. Some have their entire range of intensity adjustment so dim that illumination cannot be seen during the daytime.

Daytime illumination of reticle serves a different purpose than twilight illumination, and in such rifle scopes, high intensity levels are a necessity. In such rifle scopes, the illumination of the reticle is meant for rapid target acquisition, since a bright red dot is the best possible aiming point. Shooters’ eyes are instinctively drawn to a bright red dot in the center of the field of view. Such strong illumination is feasible only in rifle scopes with magnification lower than 1.5x or ideally 1.0x. Such wide-angle rifle scopes with a real 1.0x magnification and daytime bright illumination of the reticle can even be used with both eyes open, similar to reflex/red dot sights.

Since almost all illuminated reticles are battery powered, an automatic switch off is a usable feature that can significantly prolong battery life and operation time of such systems. Most advance reticle illumination systems even include a motion sensor that turns off the illumination (and saves battery life), when the scope is in non-shooting position (90 degrees sideways or in vertical position).

Video presentation of Illuminated reticle

Filters

Sort

In stock

EOTech Vudu 5-25x50

Ask for price

View Product

Add to compare

EOTech Vudu 3.5-18x50

Ask for price

View Product

Add to compare

Filters

Sort

VIDEO

MIL/MIL tactical scopes have all the features needed in a high-quality tactical scope. These scopes are considered as the final evolution step of the classic optical riflescopes for tactical use. The common goal of all tactical scopes is to hit the target with the first shot and to make compensation for bullet drop and wind drift as accurate and straightforward as possible. With a Mil/Mil scope, this goal can be achieved even easier. The name itself shows that these scopes have reticles that have subtensions divided in milliradians at all magnification settings and that their clicks matched with reticle subtensions and thus also in milliradians. Common features of Mil/Mil scopes are:

FFP reticle position
Reticle subtension in miliradians (MIL and mrad are acronyms for miliradian)
Click value in 0.1 mrad (1cm/100m)
Tube diameter of 30, 34, 35, 36 or 40mm

Illuminated reticle

VIDEO

Video presentation of Illuminated reticle

EOTech Vudu 5-25x50

EOTech Vudu 3.5-18x50

VIDEO

Payment methods

Shipping methods

Shopping

Contact us

Certificates

Follow us on

FAQ and Media

Illuminated reticle

VIDEO

Video presentation of Illuminated reticle

EOTech Vudu 5-25x50

EOTech Vudu 3.5-18x50

VIDEO

Your wishlist